« previous next »
Pages: [1]   Go Down

Author Topic: Need help with outdrive  (Read 1989 times)

Offline BigAl13

  • Super Hero Member
  • *****
  • Posts: 6026
  • Karma: +0/-0
  • Fish out of Keyport
Need help with outdrive
« on: March 27, 2012, 04:27:06 AM »
ok heres my issue I have an alph 1 gen 1 out drive. there are 2 trim limiters one on the port and one on the starboard. I found the end of the wires inside the transom but im not quite sure where the go too. I understand that one is for the trim gauge and the other is a limit switch used to trim all the way up for trailer ing. Do the go to the trim pump, or to the engine harness :headscra: Damn stern drives, I really need to learn more about them.
Logged
Its better to sit in a boat and think about God, than to sit in a church and think about fishing.

Offline NJ Guy

  • AKA "Virgina Beach Guy"
  • Super Hero Member
  • *****
  • Posts: 1062
  • Karma: +0/-0
Re: Need help with outdrive
« Reply #1 on: March 27, 2012, 09:33:01 AM »
I believe they go to the trim pump   t^  I have 2 alpha 1's dont be scaredddd not as bad as people make it sound
Logged
270 AmberJack "Sweet Emocean"

Offline striperdad

  • Sr. Member
  • ***
  • Posts: 402
  • Karma: +0/-0
Re: Need help with outdrive
« Reply #2 on: March 31, 2012, 01:41:06 PM »
Clymers or Seloc manuals have complete wiring diagrams for your application. Found very useful when I restored my '74 Cruisers Inc.
Logged
Pages: [1]   Go Up
« previous next »
 

NJSFlogofinal1

BSX

terrafin

Heavy Duty truck Parts On Line

Web Site Design

Bill Chaser Charters

Know Before You Go

Local Weather | Marine Bouy Weather | Inshore Forecast | Offshore Forecast | Interactive Wind Charts | Tide Charts | Sea Surface Temps | Chlorophyll Concentrates | Online Chart Viewer

-

new jersey marine weather forecastterrafin

-