NJ Saltwater Fisherman Forums

Boating => Boating General Discussions => Topic started by: mcyc on February 03, 2010, 11:41:13 AM

Title: 2 stroke
Post by: mcyc on February 03, 2010, 11:41:13 AM
Looking at getting my first boat.  I found a 2003 Parker Boat 2120 w/ a carbed 150. What are the biggest downsides of getting a two stroke?
Title: Re: 2 stroke
Post by: CapBob on February 03, 2010, 11:48:16 AM
Try this link should answer a lot

http://smalloutboards.com/4Stroke.htm


The modern 2 strokes that are fuel injectd and oil injected are just as efficiant as a 4 stroke.

I have a 225 Yammi that is fuel and oil injected no problems. As with anything you have to care and maintain them......

A 4 stroke is quieter, but also weigh more about 1/3 to 1/2 more weight than a 2 stroke depending on the HP.

Long and short is a quality engine will serve you well. TT^

Hope this helps a tad
Title: Re: 2 stroke
Post by: IrishAyes on February 03, 2010, 12:08:25 PM
I had a 2-stroke Yahama on the tail end of my Parker for 13-14 years. It had 1500 hours on it and was still running strong. No issues with it but it's age. I was getting ready to retire and could afford a new motor so I sprung for a 4-stroke.

As CaptBob said, quieter. Also, no oil usage with every trip. Not a big thing but...

It will really be a matter of personal opinion as to which is better. You have faithful followers of both engines. You can not go wrong with either.  t^
Title: Re: 2 stroke
Post by: Hotrod on February 03, 2010, 12:39:25 PM
Cost will be your factor  t^  That's basically what it will come down to.  would I buy a boat with a 2 stroke.  Sure.  would I rather have a 4stoke.  yes  t^
Title: Re: 2 stroke
Post by: mcyc on February 03, 2010, 05:55:25 PM
Thanks Fellas.  Well hopefully if all goes well ill have a 2003 150 carbed Yamiha on a parker 2120...
Title: Re: 2 stroke
Post by: Hotrod on February 03, 2010, 11:24:31 PM
yeap t^  My 93 rude ran fine with  a half of piston t^
Title: Re: 2 stroke
Post by: Maritime Matt on February 07, 2010, 07:00:14 PM
The Yamaha carbed motors are one of the best out there. I see very few of these in my shop for anything other than routine maintainance.
Only downside is if you don't like the smoke.