NJ Saltwater Fisherman Forums

Boating => Boating General Discussions => Topic started by: Reel Time on April 07, 2007, 07:53:53 AM

Title: any1 use/get yamaha's command link?
Post by: Reel Time on April 07, 2007, 07:53:53 AM
 looking to go with the command link system for the fuel management since i cant use flowscan with my motor.

 i have been looking and searching the web but cannot find any info about the system, such as what is needed and where to get it.
Title: Re: any1 use/get yamaha's command link?
Post by: Capt. Ed on April 07, 2007, 10:49:06 AM
Hi Reel Time,

Give my close friend, Bob Tweer, a call at Hobby Lobby Marine (732-929-1711) or http://www.hobbylobbymarine.com/.

He is a Yamaha Distributor (only 3 in the state - more about that at a later time). He can lead you in the right direction.

Tell him Eddie Marut referred you ... if you would prefer, I can call him for you.

Best wishes,

Capt. Ed
Title: Re: any1 use/get yamaha's command link?
Post by: Reel Time on April 07, 2007, 03:14:46 PM
 you know, honestly they where one of the places i was gonna call. was referred to go there for my services also, and they are close to where im slipped, so i'll give them a buzz durign the week on lunch break.
Title: Re: any1 use/get yamaha's command link?
Post by: Capt. Ed on April 07, 2007, 08:17:53 PM
Hi Reel Time,

Mark (head mechanic) is a good friend and btw, he is a good fisherman.

Bob Tweer and his brother are "get it done" people.

If you need help, call me on my cell (732-859-1212) and I am sure he will help out.

Best wishes,

Ed
Title: Re: any1 use/get yamaha's command link?
Post by: Reel Time on April 07, 2007, 08:59:20 PM
 awesome, i will deffinently drop your name, i will call monday on lunch.

 dont know how much this will be, but if its steep like i think it will be, it might have to wait another week or two.
Title: Re: any1 use/get yamaha's command link?
Post by: Reel Time on April 11, 2007, 09:36:54 PM
 well, it turns out i can use flowscan on my motor, the info from flowscans web site is a little vauge on what  models its refering to, think its the i/o motors, or older models or some crap. my motor, an '06 f150 does not have the duel fuel pumps that flwo scan says,, it turn out it has an engine driven mechanical fuel pump.
 
 called yamaha directly and spoke to thier marine dept, and was squared away in no time. and i must say i was very satisfied with the service i recieved. the call taker had to call me back so he could research the whole deal to confirm i was given the correct info.

 soo,, woot, no 1k+ command link system,, can get away with about $250 for a flowscan.
Title: Re: any1 use/get yamaha's command link?
Post by: Capt. Ed on April 14, 2007, 03:31:39 AM
Hi Reel,

Excellent!

Good luck with it ...

Capt. Ed