NJ Saltwater Fisherman Forums
NJ Saltwater Fishing Reports and Information => Tips, Tricks and Things to Consider => Topic started by: Pfishingruven on August 17, 2008, 10:31:56 PM
-
For anyone that uses live baitfish and has to transport them or keep them in a bucket(us nonboaters ;D), I highly recommend an aerator. I just used one for the first time today. Usually, I put the Flowtroll in the water and the killies or shiners die after just a couple of hours...if that long. I think it is b/c of the change in water type and temperature. Today, I immediately put the aerator in the bucket after leaving the bait store and NOT 1 killie died in the 4 hours I had the bait. 4 hours later they were also just as lively as when they were put in the bucket. It was amazing!! I didn't change the water or put the bucket in the water either.
You can get an aerator for the small bait buckets for just $7 at Walmart for their brand which works really well. They also have other brands which go up in price to $25. I think for long term bait keeping, one of the insulated buckets would work well too, keeping the water cooler!
I have heard of other better ways to keep bait as well, but if you keep your bait in water...an aerator is a must. Give it a try, you'll be hooked!!
Thanks
TT^
-
t^
-
Another way is to make a killie cart. Take a small cooler (6 pack size), load the bottom with ice, put a wet towel over the ice and the killies on the towel. The secret to this is to not allow the killies to come in contact with any water when the ice melts or direct contact with the ice itself. Killies will last all day.
The cold temp slows down their metabolism. When you take a killie out of the cart it will be pretty much lethargic. Once it hits the water it will 'wake up' and be as good as new. TT^
-
Cool...thanks Capt Joe! I knew there was another way, but I never knew the technique. I was just so tired of dumping bait out that was dead after a very short time!! Not that it is expensive, but limited my fishing days...so much that I will pass on bait most of the time when I go fishing.
I think I need to invest in a small cooler!!
TT^
-
Hey Capt Joe, do you know if a killie cart works for shiners too??
Thanks
TT^
-
Don't know about that. The killie fish is pretty hardy. Like a timex watch, takes a ===== and keeps on tickin. ;D
Don't know if a shiner will hold up to that or not.
-
t^
-
Thanks Capt Joe! I will stick to shiners in the flowtroll with the aerator. They definitely don't seem as hardy as killies.
TT^
-
Thanks Capt Joe! I will stick to shiners in the flowtroll with the aerator. They definitely don't seem as hardy as killies.
TT^
nothing is as hardy as killies.
-
Don't know about that. The killie fish is pretty hardy. Like a timex watch, takes a ===== and keeps on tickin. ;D
Don't know if a shiner will hold up to that or not.
Shiners won't last very long out of the water. Save it for killies and eels. t^
-
Air is what keeps bait alive and if you want your bait to stay in water you must inject air into the water. A battery bubble box areator is fine for a pint of minnows or a dozen finger mullet in a 5 gallon bucket. If you want more bait get a bigger tank and better areator. the best for my money are the Keep Alive Systems which will definately keep your bait liveler than anything else I have found.
The Keep Alive runs off 12 volts
The flow trolls are really just what they say for allowing water to flow thru while they are trolled thru the water. The are also referred to as minnow coffins since when you pick them up with water in the bottom there is so little water that the minnows quickly exaust the available oxygen in the bucket and DIE !
For Killies and eels the ice method is definately the best but don't let the bait come into direct contact with the ice or melted ice water.