« previous next »
Pages: [1]   Go Down

Author Topic: FLoScan issue  (Read 1333 times)

Offline Capt. Joe G

  • Sponsor
  • Hero Member
  • *****
  • Posts: 582
  • Karma: +0/-0
FLoScan issue
« on: October 25, 2010, 01:11:58 PM »
Guys I have a FLoscan issue??

The guage will not reading amount of fuel being burn..?? it reset on ignition but then needle doesn't move . Port Motor guage read good . Starboard Motor doesnt read.. Is there anything to check on connections??

Thanks Joe
Logged

Offline IrishAyes

  • Fishing At It's Finest
  • Admin
  • Super Hero Member
  • *****
  • Posts: 17408
  • Karma: +0/-0
Re: FLoScan issue
« Reply #1 on: October 25, 2010, 03:22:02 PM »
Joe, for starters can you easily exchange the wires from one to the other. Have the port engine sensor read on the stbd gauge. That should at least tell you if it is the gauge or sending unit side being an issue.
Logged
Captain Joe of the Irish Ayes

May the holes in your net be no larger than the fish in it.  ~Irish Blessing
Pages: [1]   Go Up
« previous next »
 

NJSFlogofinal1

BSX

terrafin

Heavy Duty truck Parts On Line

Web Site Design

Know Before You Go

Local Weather | Marine Bouy Weather | Inshore Forecast | Offshore Forecast | Interactive Wind Charts | Tide Charts | Sea Surface Temps | Chlorophyll Concentrates | Online Chart Viewer

-

new jersey marine weather forecastterrafin

-