« previous next »
Pages: [1]   Go Down

Author Topic: First step in rod rebuild  (Read 2530 times)

Offline Eng 94

  • Sr. Member
  • ***
  • Posts: 478
  • Karma: +0/-0
  • When the going gets tough the tough get going
First step in rod rebuild
« on: March 08, 2015, 10:15:06 AM »
These are the first steps in rebuilding the old boat rod. first step making it a one piece by doweling the blank to the old butt.

1. I center bored the wood handle with a 15/32" drill bit

2. fitting a 7/16 wood dowel to the handle w/masking tape

3. fitting the blank to the dowel

4. adjusting the blank for proper overall length

 
« Last Edit: March 08, 2015, 10:22:35 AM by Eng 94 »
Logged
I don't know the key to success,but the key to failure is trying to please everybody

Offline Pops Soul

  • SKIP <*}}}><
  • Super Hero Member
  • *****
  • Posts: 5384
  • Karma: +0/-0
  • SKIP <*}}}><
Re: First step in rod rebuild
« Reply #1 on: March 08, 2015, 10:40:14 AM »
 t^
Logged
It's Not A Knot Until You Pull It Tight!
Pages: [1]   Go Up
« previous next »
 

NJSFlogofinal1

BSX

terrafin

Heavy Duty truck Parts On Line

Web Site Design

rfasig.png

Know Before You Go

Local Weather | Marine Bouy Weather | Inshore Forecast | Offshore Forecast | Interactive Wind Charts | Tide Charts | Sea Surface Temps | Chlorophyll Concentrates | Online Chart Viewer

-

new jersey marine weather forecastterrafin

-