NJ Saltwater Fisherman Forums
NJ Saltwater Fishing Reports and Information => Helping Each Other Out => Topic started by: njadam on June 26, 2007, 10:26:04 PM
-
Hello all....I am new to this site...I know there are probably answers to this question but I wanted to get my name out there...so for the question, Could anyone reccomend a fluking rod and reel, i am looking up update my arsenal of fishing rods, i would like it to be a casting rod and am looking to spend around $120-$140, also would you recommend using braid line? thank you.
-
braid line is a must. The rod I can recomment is way more then what you want to spend, without the reel...
-
I wouldnt listen to what i have to say about the rod /reel setups, i just like shimano spinning reels with a loomis rod or an ugly stick. BUT, the pole that i use for casting spoons for blues/bass/etc, and for even fishing for fluke is i have a Flueger spinning reel with my 9 foot ugly stick. It might not even be the right setup for fluke or what not, but i have some what success with it. I enjoy fishing spinning reels the most, reeling it in with the left hand too.
Fish On
-
Adam, pretty sure I emailed you on the rods a couple days ago...did you get my email? Never heard back from you.
-
I use the loomis rod with a penn 440ss spinning reel. BUT, the rod is almost $200.00 and the reel is about $90.00
-
Efingers has a nice combo $80.00 okuma level wind and tsunami rod
will work for both fluke and stripers
-
Hi NJAdam,
Are you fluking from a boat or shore?
If from a boat, you need a rod with backbone. Look at companies like Shimano (Compre), St. Croix and Daiwa (Heartland). These are basically "Muskie Rods." These rods are about $100.
For a reel for $40 or so, the Penn 209 is an all time workhorse that will fit perfectly with any of those rods.
I would tend to buy a better rod now and you can always upgrade the reel and make it a backup.
I really like the Shimano 6'6" Compre. The Penn 209 is an all-time favorite. You can also go with a Penn 500 Jigmaster in that price category.
Have fun,
Capt. Ed
-
thanks for all the quick responses i will take a look at all of them....and Avid i just joined this site about 1 hour ago so it was not me who you emailed.....but your recommendation on a rod and reel would be appreciated
-
hi njadam, and wlcoome to the site. for abouts 100 bucks, will be hard, for abouts 150 will open up the doors a little more.
what i have used and like, plus cheap,,,
an abu garcia ambassadeur,, catn go wrogn with these reels. and from bass pro shops there is a 15 buck rebate.
(http://image.basspro.com/images/images2/91500/91745a.jpg)
for a pole i'm into liking the tsunami rods. got myself one thats xxheavy and it works good with a 10oz sinker. they can be found locally for about 70 bucks, give or take.
-
Welcome njadam....As Capt Ed has stated, I like the the Daiwa (Heartland Muskie rod). It has plenty of back bone and isn't that expensive. I have mine matched to an Abu-Garcia 6500 TCST level wind reel. This is a light set up (weight wise)and can be fished all day without winding up with arms of lead.
Hope this helps you make a decision that you will be happy with. Good luck & tight lines.
Capt. John K.
PS: I use braided line on the reel.
-
Hello all....I am new to this site...I know there are probably answers to this question but I wanted to get my name out there...so for the question, Could anyone reccomend a fluking rod and reel, i am looking up update my arsenal of fishing rods
Fishing the bay or ocean?
-
Skolmann, I will be fishing both the bay and ocean, mostly the bay but i usually dont venture out into the ocean more than a mile or 2 for fluke
-
Give me a day or 2 & I'll post some model #s.
-
Take a look at the Shimano Compre CP70M (or the slightly heavier 70MH). Both should be around $99.
The Seeker BA-85 is a great all around rod (fluke, blackfish, stripers) but may be a tad heavy for bay fluking. Runs between $120-$135.
Might want to check out Bogan's Bait & Tackle in Pt. Pleasant. They make some nice custom rods. I've seen some real nice fluke sticks there for under $150.
I'm sure you could find a nice St. Croix to fit the bill for @ $120ish.
If you're going to fish braid, take a look at the Lamiglas Tri-Flex series. I personally don't like this series because the foregrip is too small to my liking but I have other Lamiglas rods & love them. Think they also run around $120.
Alot of people like using "musky" rods for fluke. I do as well but only when heavier weights (say over 5 ounces) are need so again may not be the best for the shallower bay waters.
Here's a tip when you go into the store to buy your rod. Bring a few sinkers in various weights and a small length of mono. Attach the sinker to the mono via a end loop and the opposite ned of the mono to the rod tip. This will give you an idea on how the rod feels with weight on it. Good idea to bring at least 1 sinker that is the maximum amount of weight you plan on using on the rod.
-
Now that is something I never thought about Skolmann. Bringing the sinkers. It surely beats the bend the rod up on the ceiling test. t^
-
Now that is something I never thought about Skolmann. Bringing the sinkers. It surely beats the bend the rod up on the ceiling test. t^
Yea every so often I have a good idea.... ;D
-
thank you...i love the idea about the weight i will definetly give that a try
-
One last rod you might like to consider. Granted you may have a very difficult time finding it as I not sure if it is still in production. I came across this rod about 3 years ago. I initially bought 1 for my son and liked it so much that I bought another for me a few weeks later. In fact I liked it soooooooooo much that a year later I bought another one (from the same store in Jersey City-it just happened to be their last).
It's a 7' Penn GLS 700. If I'm not mistaken it's originally a Sabre blank but when Penn bought out Sabre they produced it. Matchs prefectly with a Penn 955 reel. GREAT fluking stick for dragging bait in both the bay & ocean as well as bucktailing up to 6 ounces. My also will use his as a backup jigging stick in the fall.
I haven't tried (since I already have 3 of these rods) but you might want to a detailed search on the internet. You never know, you might luck into one or 2.